Home > News > Content

The Inner Wallboard Equipment Should Be Maintained When Not In Use

Jun 02, 2017


Maintenance and maintenance of interior wallboard equipment! Here we look at how specific operation should be.

1. Each class to the wallboard vibration guide bar filled with butter and the relevant parts to check, adjust, clean, refueling and other routine maintenance, but also should do the following maintenance work as follows; according to the actual working hours, the cumulative operation of a certain Time, Inner Wall Plate Equipment need to change the gear box for the oil, add new oil before the application of kerosene or diesel fuel tank will be clean. Regularly check the gear box oil level, if close to the lower limit should be immediately added to the upper limit. According to the provisions of the summer to join HL-30 gear oil, winter by adding HL --- 20 gear oil, is not allowed to mix different grades of gear oil. Inner Wall Plate Equipment Oil seal failure oil leakage, oil seals should be replaced in a timely manner.

2. The vibrator of the internal wallboard equipment shall be maintained in accordance with the following provisions;

A, vibrator in the handling and operation, Inner Wall Plate Equipment should pay attention to light to prevent knock damage.

B, the appearance of the chassis should be kept clean, so as not to prevent the motor cooling.

C, vibrator operation, such as abnormal sound or abnormal sound conditions and the coke odor should immediately disconnect the power, stop inspection.

D, rolling bearing grease pay attention to regular cleaning, in the vibrator moving 150 to 200 hours to replace once, the coating can not be too much to fill the bearing cavity is one-third is appropriate, so as to avoid bearing heat.

E, regularly check the bearing, oil seal and other wearing parts of the wear and tear, Inner Wall Plate Equipment such as the problem must be promptly replaced.

3. When the internal wall board equipment squeeze operation, if the system board bad quality and forming a serious decline in the speed should be shut down check the mixing knife, wall panels, vibration plates and other wearing parts; replace the knife, it should be symmetrical Replacement to ensure uniform feeding.

4. The wallboard equipment shall not be exposed to the ground, long-term need not, Inner Wall Plate Equipment the key parts should be coated with oil protection, and make two front wheel and two rear wall panels touch the four corners, horizontal to reduce the deformation.

In addition to the use of maintenance in accordance with the provisions of this manual, the user should also develop a safe operation of the extruder procedures, the implementation of capacity to ensure the normal operation of the machine to produce qualified products.