Home > News > Content

Precautions In The Use Of Cold Bending Mechanical Equipment

Feb 05, 2018

With the continuous development of China's industry, cold bending technology has also been a rapid development. Cold bending machinery equipment to become some professional factory indispensable machinery. So the cold bending machinery and equipment used in the same place to be noted.

First of all to choose the flat table, put the machine, you can pull off the chassis to make the machine panel easy to observe. Insert the plug on the handheld sensor head into the socket on the panel and tighten it, paying attention to locating the notch.

Second, plug one end of the power cord into the rear panel of the chassis socket, the other end into the power supply socket, please be sure to use single-phase three-wire power supply. Then turn on the "power SW." On the rear panel of the chassis and press the "power switch (switching)" key, and the machine will work if the "Ready (WARM up)" green indicator is lit. Press and hold the Set button (SETTING button) to set the appropriate value, usually between 0.5-2 seconds.

Again put the sensor head on top of the container, click on the handle of the Start button, when the "heating (heating)" Red indicator light, said to be heating, the sensor head do not move away, "heating (heating)" Red led out and then remove the sensor head.

Finally, the "Ready (WARM up)" Green indicator light or in-machine buzzer short sound "beep" prompts can also carry out the next container sealing operations. Check the sealing quality, according to different material, diameter of the container and production efficiency, appropriate trimming "set button (SETTING button) key, make the sealing quality best."