Home > News > Content

Matters Needing Attention In The Use Of Cold Bending Equipment

May 20, 2017

First of all, choose flat surface, stable machine, you can open the foot of the chassis, so that the machine panel is easy to observe. Plug the plug in the hand sensing head into the socket on the panel and screw it tight. Pay attention to the notch.

Next, plug one end of the power cord into the socket on the rear panel of the cabinet, and plug the other end into the power supply socket. Make sure to use the single-phase three wire system. Then turn on the power switch (POWER SW.) on the rear panel of the cabinet. Press the panel "power switch (SWITCHING)", and "UP (WARM)", the green indicator light is on, the machine will work. Hold down the "SETTING BUTTON" button, set to the appropriate value, usually between 0.5-2.0 seconds.

Again, the sensing head cover on the container, click on the handle of the start button, then the "heating (HEATING)" red light, said it is heated, remove the sensor head don't, "heating (HEATING)" red light is off after removing the sensor head.

Finally, such as "UP (WARM)" green indicator light or buzzer inside the machine short beep "beep" prompt, and then you can carry out the next container sealing operations. Check the sealing quality, according to different materials, diameter containers and production efficiency, properly trimmed "set button" (SETTING BUTTON) key, so that the best sealing quality.


Pinghu Jin Wei Machinery Technology Co., Ltd